CONSULTAS DE SERVICIO TÉCNICO ELECTROCARS
| CARACTERÍSTICAS: | TWIN CHANNEL GUITAR AMP COMBO WITH HIGH GAIN PREAMP, 3 BAND EQ, AUX IN & CABSIM-LOADED HEADPHONE OUTPUT |
|---|---|
| PANEL SUPERIOR (DE DERECHA A IZQUIERDA): | ENTRADA DE INSTRUMENTO, CLEAN VOLUME, DIRTY GAIN, BASS, MIDDLE, TREBLE, DIRTY VOLUME, CHANNEL SELECTOR SWITCH, AUX IN, SALIDA DE CASCOS |
| PANEL TRASERO: | CONECTOR DE PEDAL DE CAMBIO (EL PEDAL SE VENDE POR SEPARADO) |
| OPCIONES DE ACABADO: | NARANJA O NEGRO – VINILO “BASKETWEAVE” |
| POTENCIA: | 20 VATIOS |
| ALTAVOZ: | CUSTOM 8″ VOICE OF THE WORLD |
| MEDIDAS SIN EMBALAJE (ANCHURA X ALTURA X PROFUNDIDAD): | 37.5 × 32.5 X 19.7CM (14.67 X 12.8 X 7.75″) |
| PESO SIN EMBALAJE: | 7.15KG (15.8LB) |
| 1. POWER | THE POWER LIGHT WILL ILLUMINATE WHEN THE POWER SWITCH (REAR) IS SET TO ON. |
|---|---|
| 2. PHONES | CONNECT HEADPHONES VIA A STEREO 1/4″ JACK FOR SILENT PRACTICE. THE PHONES OUTPUT FEATURES CABINET SIMULATION AND CAN ALSO BE USED TO CONNECT THE AMP TO A MIXER OR RECORDING CONSOLE. AVOID USING HEADPHONES FOR EXTENDED PERIODS AT LOUD LEVELS. |
| 3. DIRTY CHANNEL VOLUME | ADJUSTS THE OUTPUT VOLUME LEVEL ON THE DIRTY CHANNEL. NOTE: WITH THE DIRTY CHANNEL GAIN SET TO ZERO, NO SOUND WILL BE HEARD ON THE DIRTY CHANNEL. |
| 4. TREBLE | ADJUSTS THE HIGH-END FREQUENCIES. INCREASING THE TREBLE CONTROL PRODUCES BRIGHTER TONES. |
| 5. MIDDLE | ADJUSTS THE MID-RANGE FREQUENCIES. INCREASING THE MIDDLE CONTROL PRODUCES A ‘FATTER’ SOUND. WITH HIGHER OVERDRIVE SETTINGS, REDUCE THE MID-RANGE FREQUENCIES FOR A MORE ‘SCOOPED’ MODERN TONE. |
| 6. BASS | ADJUSTS THE LOW-END FREQUENCIES. INCREASING THE BASS CONTROL PRODUCES DEEPER TONES. |
| 7. GAIN (DIRTY CHANNEL) | EXPERIMENT WITH THE GAIN CONTROL FOR A WIDE RANGE OF ‘CRUNCH’ AND HEAVILY DISTORTED TONES. HIGHER SETTINGS ADD MORE DISTORTION AND SATURATION. BALANCE WITH THE DIRTY VOLUME CONTROL TO ACHIEVE THE DESIRED OUTPUT LEVEL. |
| 8. CLEAN CHANNEL VOLUME | ADJUSTS THE OUTPUT LEVEL ON THE CLEAN CHANNEL. HIGHER SETTINGS ON THE CLEAN CHANNEL WILL PRODUCE NATURAL OVERDRIVE AND BREAKUP. |
| 9. INPUT | USE A QUALITY SHIELDED INSTRUMENT CABLE TO CONNECT YOUR INSTRUMENT TO THE INPUT JACK SOCKET. |
| 10. AUX IN | CONNECT MP3 PLAYERS ETC. TO THE AUX INPUT USING A 3.5MM STEREO JACK. NOTE: AUDIO IS SUMMED TO MONO AND IS UNAFFECTED BY THE AMP’S CONTROLS. |
| 11. CLEAN/DIRTY SELECTOR SWITCH | SELECTS BETWEEN THE CLEAN AND DIRTY CHANNELS. THIS CAN BE SWITCHED REMOTELY VIA A FOOTSWITCH (SEE REAR PANEL) |
| 1. AC MAINS INPUT | REFER TO ‘BEFORE USING YOUR AMPLIFIER’. CONNECT THE SUPPLIED IEC CABLE TO THE AC MAINS INPUT. ENSURE THE POWER SWITCH IS SET TO OFF BEFORE CONNECTING THE IEC CABLE. |
|---|---|
| 2. MAINS FUSE | THE MAINS FUSE IS LOCATED IN THE PULL-OUT TRAY UNDERNEATH THE AC MAINS INPUT. IF THE MAINS FUSE BLOWS, REPLACE ONLY WITH THE EXACT RATING FOR YOUR REGION . IF THE MAINS FUSE CONTINUES TO BLOW CONTACT YOUR ORANGE DEALER. 100V/120V: T315MA |
| 3. VOLTAGE SELECTOR SWITCH | IMPORTANT! REFER TO ‘BEFORE USING YOUR AMPLIFIER’. FACTORY SET TO THE REGION IN WHICH THE AMPLIFIER IS INTENDED TO BE SOLD. |
| 4. POWER SWITCH | ENSURE THE AMP’S VOLUME CONTROLS ARE SET TO ZERO BEFORE SWITCHING ON POWER TO THE AMPLIFIER. SWITCH OFF WHEN NOT IN USE. |
| 5. FOOTSWITCH | CONNECT A LATCHING FOOTSWITCH (E.G. FS-1) TO REMOTELY SWITCH BETWEEN CLEAN AND DIRTY CHANNELS. THE FRONT PANEL CHANNEL SWITCH IS DISENGAGED WHEN USING A FOOTSWITCH. AN ORANGE FS-1 LED WILL ILLUMINATE WHEN THE CLEAN CHANNEL IS SELECTED. |
"Si tu Orange Crush 20 se encuentra en falla , produce ruido al encenderlo , contáctanos para poder dar solución a tu equipo , reparamos una amplia gama de amplificadores de guitarra , también ofrecemos asesoramiento, si cuentas con conocimientos en soldadura puedas reparar tu equipo desde cualquier parte del mundo, ya que contamos con transferencia en USD de Paypal , estamos dispuestos para ayudarte" .
atentamente ,
Electrocars Servicio Técnico.
